Pogoplug V2 Overclocking

This forum is for Marvell Kirkwood devices such as the GoFlex Home/Net, PogoPlug v1/v2, SheevaPlug, and ZyXEL devices.

Pogoplug V2 Overclocking

Postby titojackson » Fri Nov 16, 2012 4:23 pm

Searched around and couldn't find anything except for the Raspberry Pi so I figured I would ask here:

Anyone every tried overclocking the processor on the Pogo v2? How did it go, and how did you go about it? Thanks,

Tito
titojackson
 
Posts: 7
Joined: Wed Nov 14, 2012 2:30 am

Re: Pogoplug V2 Overclocking

Postby xenoxaos » Fri Nov 16, 2012 4:28 pm

The kirkwood's clocking is set by resistor jumpers soldered onto the device boards. It's not easy/or recommended.
Arch Linux ARM exists and continues to grow through community support, please donate today!
xenoxaos
Developer
 
Posts: 323
Joined: Thu Jan 06, 2011 1:45 am

Re: Pogoplug V2 Overclocking

Postby winestock » Fri Nov 16, 2012 6:27 pm

xenoxaos wrote:The kirkwood's clocking is set by resistor jumpers soldered onto the device boards. It's not easy/or recommended.


How about the Pogoplug Series 4?
Pogoplug Series 4 / Linux-Kirkwood 3.10.10-2
winestock
 
Posts: 134
Joined: Mon Nov 05, 2012 12:03 am

Re: Pogoplug V2 Overclocking

Postby WarheadsSE » Fri Nov 16, 2012 7:35 pm

The V4 is also a kirkwood.
OXNAS pwner

Remember: Arch Linux ARM is entirely community donation supported!
WarheadsSE
Developer
 
Posts: 4521
Joined: Mon Oct 18, 2010 2:12 pm


Return to Marvell Kirkwood

Who is online

Users browsing this forum: No registered users and 0 guests