hello,
I have the reset cause POR problem when booting my udoo
Here is the message given by my board:
U-Boot 2015.01 (Jan 24 2015 - 18:35:39) Arch Linux ARM
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: Udoo
DRAM: 1 GiB
MMC: FSL_SDHC: 0
In: serial
Out: serial
Err: serial
Net: using phy at 6
FEC [PRIME]
Hit any key to stop autoboot: 0
switch to partitions #0, OK
mmc0 is current device
SD/MMC found on device 0
Checking for: /boot/uEnv.txt ...
The board is boot-looping
Does it software problem or hardware one ..
I use a 12V 2000mA given with the Udoo
Thx for your help