I build/installed a CAN driver peak-linux driver 7.5 on pandaboard with 3.2.0 Omap 1411 distribution.
But at running, a big latency is observed (sending frames and receiving last values updated 1S to 2S later).
Some one know if PandaBoard is not optimized to perform CAN network communications? or if my distribution if not ok for CAN network? or peak driver is not compatible with Panda Hardware?...
All your suggestions are welcome..
PS: my application is well running on a linux laptop
Thanks in advance for your response.
Last edited by xenoxaos
on Thu Apr 26, 2012 9:30 pm, edited 1 time in total.
Reason: Capitalized CAN to make it appear to have better grammar.