hi everyone!
I followed the guide who's in the wiki page to configure i2c-tools, but when I get to the point of launching this command:
$this->bbcode_second_pass_code('', '
i2cdetect -y 0
')
this is the output:
$this->bbcode_second_pass_code('', '
[marco@ArchRPi2 ~]$ sudo i2cdetect -y 0
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
70: -- -- -- -- -- -- -- --
')
What I'm doing wrong?
thank you very much!!!!!!!