Hello,
I have pogoplug v4.
I've been trying to understand what I'm doing wrong.
Followed some of the mknod from http://blog.qnology.com/2014/07/hacking-pogoplug-v4-series-4-and-mobile.html
And rest of installation from http://archlinuxarm.org/platforms/armv5/pogoplug-series-4
All in all:
[*]mknod /tmp/mmcblk0 b 179 0
[*]/sbin/fdisk /tmp/mmcblk0 #created the partition
[*]mknod /tmp/mmcblk0p1 b 179 1
[*]/tmp/mke2fs -L rootfs -j /tmp/mmcblk0p1
[*]tar -xvzf ArchLinuxARM-kirkwood-latest.tar.gz /alarm
For 3 times I've installed the Archlinux on 2 mmc devices (on sd with 8 GB mem hc the other 2 GB).
In both times I get (got so frustrated that I've connected the serial since only got a green blinking light) :
Integrated Sata device found
** Can't read from device 0 **
** Unable to use usb 0:1 for fatls **
IDE device 0 not available
** Bad partition 1 **
What is wrong with my partitions?