SNMP support on Pogo B01

[Gazineu]

Hi,

When trying to set up a snmp daemon on a pogoplug classic, the system return the following error:
$this->bbcode_second_pass_code('', 'pcilib: Cannot open /proc/bus/pci
pcilib: Cannot find any working access method.')

The kernel used by default is the uImage.nopci on this model, and I think that a kernel supporting pci can solve the lib problem without having to change the lib code.

I know that installing the uImage.pci can be done with some commands:
$this->bbcode_second_pass_code('', 'removed')
The question is: Without the pci hardware on this model, will this work without bricking the device?

Thanks in advance.

[WarheadsSE]

WRONG

If you have B0x, it has no PCI bus. DO NOT use the pci uImage, they are separated for a reason.

Also,
THAT NANDWRITE COMMAND WILL BRICK YOUR DEVICE, AS YOU HAVE NO PCI.

If you don't know what you are doing in writing NAND, then don't do it. NAND must be erased prior to being written to, if there was any content there prior, and if you do that math wrong, you've got an even bigger brick.

[Gazineu]

Thanks, man.

Also, any clues on how to get libpci/snmp working, anyone?

Rgds.

[WarheadsSE]

You don't have PCI on that, so it shouldn't be an issue at all.

[Gazineu]

Please read the error that snmpd gave me on first post...

[WarheadsSE]

Then you should look into the snmp daemon, and tell it to stop trying to read the pci, because it doesn't exist.

[fljx]

Sorry to annoy you, Gazineu, but did you get any solution for your problem?

I am facing the same question with a PowerPC embedded board and could not find much information around the Internet.
Any help would be really wellcome.

Thanks!

[Gazineu]

No, I have not...

I'm in the same position - snmpd won't run, and returns the error below:

$this->bbcode_second_pass_quote('', '
')# rc.d start snmpd
:: Starting Net-SNMP [BUSY]
pcilib: Cannot open /proc/bus/pci
pcilib: Cannot find any working access method. [FAIL]

$this->bbcode_second_pass_quote('magicfinger', 'I')'m in the same position - snmpd won't run, and returns the error below:

$this->bbcode_second_pass_quote('', '
')# rc.d start snmpd
:: Starting Net-SNMP [BUSY]
pcilib: Cannot open /proc/bus/pci
pcilib: Cannot find any working access method. [FAIL]