As you might know they have been selling the PogoPlug for just $20 & $25 at Buy.com and JR.com.
The black version I got a few days ago at Buy.com is marked as POGO-P21.
I tried installing ArchLinux as shown in these instructions:
http://archlinuxarm.org/platforms/armv6 ... provideov3
After completing step 10 it says:
$this->bbcode_second_pass_code('', '-bash-3.2# ./oxnas-install.sh
#############################
##
## Pogoplug OXNAS based boards
## Arch Linux ARM rootfs Installer
##
#############################
##
## For use with OXNAS 7820 only.
##
#############################
## PREPARATION
# Switching to /tmp...
# Ensuring we're ready to proceed...
killall: hbwd: no process killed
umount: cannot umount /dev/sda1: Invalid argument
# Preparing our way...
# Getting uboot parameters...
# = MAC : 00:25:31:02:0F:EE
# = load_nand :
# = bootargs : console=ttyS0,115200 root=/dev/mtdblock2 ro
# = board : PPV2
#
# Checking board revision...
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
ABORTING!!! UNSUPPORTED MODEL
=================================
See the wiki on models supported
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!')
Here is the CPUINFO:
-bash-3.2# cat /proc/cpuinfo
Processor : ARM926EJ-S rev 1 (v5l)
BogoMIPS : 1192.75
Features : swp half thumb fastmult edsp
Please help! There will be tons of people looking for help to install ArchLinux because this server has become quite cheap.
Is this device indeed supported? If not, how can I revert back to the way it was?
Thanks!