I updated my Archlinux a couple of days ago and installed Webmin and MiniDLNA, both running without issue.. Today I had a power outage and when the power came back up, my Pogoplug failed to boot from the external hard disk Archlinux is installed on.. I've experienced this before whenever the Pogoplug loses power, it will fail to boot back into Archlinux
UNLESS I disconnect the other external hard drives I have connected to it.. Once Archlinux is booted up and running, I can reattach the external drives and they will automount and become active.. Today I did that and could not access the files on those drives, but according to Webmin they were mounted but not in use.. One drive I was able to start by clicking the 'No' button under "In use?" and it turned into 'Yes', but the other needed to be unmounted and remounted to start..
I live in a rural area where power outages are really common, and this routine is starting to wear on me.. Is there anyway to have the Pogoplug boot from the external drive with Archlinux while the other external drives are connected during a cold boot? What do I need to set to make sure the other two drives are mounted and in use when this occurs?
Here are just some screen captures of my mounts and what they are set at..