linux-kirkwood-dt 4.11.3-1

by **WorldwoWires** » Wed May 31, 2017 5:08 pm

There is an issue with mounting sata (GFH) after update.

sata_mv f1080000.sata: can't request region for resource [mem 0xf1080000-0xf1084fff]
sata_mv: probe of f1080000.sata failed with error -16

by **Kabbone** » Wed May 31, 2017 8:07 pm

same problem here. Downgrade of the kernel solved it temporarily

by **bodhi** » Wed May 31, 2017 9:49 pm

@moonman,

There was a regresion in sata_mv in kernel 4.11. Go back to latest 4.10.x version for sata_mv.c solved it.

-bodhi

by **boteium** » Thu Jun 01, 2017 2:44 pm

Is there any mirror site that still holds linux-kirkwood-dt 4.10.12 ?

by **summers** » Thu Jun 01, 2017 9:01 pm

Think this may have just bitten me - kirkwood device (NSA325) and after latest kernel upgrade, it refused to reboot. Just redoing the OS for last known good tar ball, as I never wired up the UART on this box ...

by **summers** » Fri Jun 02, 2017 7:11 pm

OK - I've gone back to the last tar ball - but its the not dt kernel. Now of course if I upgrade to the dt kernel - I'll get the latest, and it will crash again.

So can someone shout when the dt tree is fixed, so I can then change back to it ...

by **moonman** » Sat Jun 03, 2017 1:54 am

Im going to work on it over the weekend. I am of course not booting off the sata. There is a roll back machine post pinned under Community Guides so you can grab a package there.

@bodhi, thanks for the heads up on whats wrong

by **planeteater** » Sat Jun 03, 2017 9:33 am

I'm booting from usb on a Zyxel NSA320, and even after removing the internal sata disks, the kernel still hangs at this point:

$this->bbcode_second_pass_code('', '
[ 3.526019] scsi 0:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6
[ 3.536338] sd 0:0:0:0: [sda] 60062500 512-byte logical blocks: (30.8 GB/28.6 GiB)
[ 3.544546] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 3.550694] sd 0:0:0:0: [sda] Write Protect is off
[ 3.556351] sd 0:0:0:0: [sda] Mode Sense: 43 00 00 00
[ 3.562118] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[ 3.597028] sda: sda1 sda2
[ 3.604899] sd 0:0:0:0: [sda] Attached SCSI removable disk
')

by **planeteater** » Sat Jun 03, 2017 12:42 pm

Ignore my previous post!
When booting from usb, 4.10.12-2 boots fine when my sata hdds are in place, but without disks it hangs the same way as described above, so that issue is not related to the upgrade.

by **boteium** » Sat Jun 03, 2017 1:02 pm

Yeah, 4.11.3 boots fine with external usb.
My system had been on the usb ever since flashing of ALarm's uboot.

linux-kirkwood-dt 4.11.3-1

linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Re: linux-kirkwood-dt 4.11.3-1

Who is online