[UDOO] Uboot can't load kernel.. Bad data CRC

[jerrino77]

Hello, i'm using debootstrap method to install Debian armel image to sd card. Following the guide on eLinux, i have to download uImage from sources and copy it to /boot SD partition. But when i boot, i get this $this->bbcode_second_pass_code('', 'UDOO board => boot
mmc0 is current device
** File not found boot.scr **
4372753 bytes read in 421 ms (9.9 MiB/s)
Booting from mmc ...
** File not found imx6q-udoo.dtb **
## Booting kernel from Legacy Image at 12000000 ...
Image Name: Linux-3.0.35
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 4372724 Bytes = 4.2 MiB
Load Address: 10008000
Entry Point: 10008000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!')" uboot loadaddr is 0x12000000

If I copy the "precompiled" image (Debian or ArchLinux doesn't matter) everything works fine, but I need a very small image without DE and i prefer debian because i already know the enviroinment.
The same thin is when i try to compile a uImage by myself (to include XFS support) directly on Udoo, with the new kernel i get the same error.

Please help me to boot my UDOO!!!

[djman]

Could you show your bootargs and bootcmd? I think your Image is too big, if the kernel size bigger than the bootcmd's parameter, then the uboot can't get all the kernel to the memory, so kernel can't start.

[kmihelich]

This is not a Debian forum, as evidenced by the logo at the top of the page.