[iConnect] Post-install customization

[Conn]

To make a minor contribution post according to this topic :

I strongly recommend using a HDD to take iConnect installation up to another level. To migrate your "already installed to USB Stick system" I'd suggest using Clonezilla (http://www.clonezilla.org/liveusb.php). It works perfectly and it even checks your filesystem and resizes the new partition.

@igor : Thank you. Although my system works just fine I'd like to fix "HDIO_GET_IDENTITY" message. Do you know a way?

How can we start a wiki under www.archlinuxarm.org for iConnect? Although iConnect is a Community Supported Device, maybe we can prepare an official support page...

Regards,
Conn

[kmihelich]

If someone would like to prepare a step-by-step mostly-idiot-proof in (at least close to) the same format as our other installation pages, I'll get it into it's own page.

Just clear, concise instructions is all I'm after. We don't bother with highlighting or trying to pound in important points beyond simply stating them, because it's been proven that it doesn't work anyway. If there are different approaches for USB vs. SATA, two sets of instructions are fine or just splitting steps for the two alternatives. Either way, with a good set of steps I can clean them up and make them match our style for other devices.