[Solved] SATA Harddisk not recognized on BananaPro

Install Arch Linux ARM on other devices.

[Solved] SATA Harddisk not recognized on BananaPro

Postby Vorwaerts » Tue Jan 03, 2017 8:59 pm

After a fresh installation according to the guide at https://wiki.archlinux.org/index.php/Banana_Pi my BananaPro does not recognize the hard disk connected to the SATA port.
Before I did an update with pacman -Suy last desember it was working fine. The BananaPro would not restart after the backup, because it did not find the SATA drive. Therefore I tried a new installation. ]lsblk shows only the SD card and no SATA drive.
If I restart the BananaPro with a Bananian installation (https://www.bananian.org/) on a different SD card, lsblk lists both the SD card and the SATA drive.
Could anyone give me some hints on how to troubleshoot this issue?
Last edited by Vorwaerts on Tue Jan 10, 2017 8:57 pm, edited 1 time in total.
Vorwaerts
 
Posts: 2
Joined: Tue Jan 03, 2017 8:26 pm

Re: [Solved] SATA Harddisk not recognized on BananaPi

Postby Vorwaerts » Tue Jan 10, 2017 8:56 pm

Ok I found the solution.

The u-boot has to be compiled with the BananaPro config.

I.e. install as described here: https://wiki.archlinux.org/index.php/Banana_Pi
but replace
Code: Select all
make -j4 ARCH=arm CROSS_COMPILE=arm-none-eabi- Bananapi_defconfig

with
Code: Select all
make -j4 ARCH=arm CROSS_COMPILE=arm-none-eabi- Bananapro_defconfig
Vorwaerts
 
Posts: 2
Joined: Tue Jan 03, 2017 8:26 pm


Return to [Please read announcement] Community-Supported Devices

Who is online

Users browsing this forum: No registered users and 2 guests