i apologize for my poor english
i do it and all is OK , but not out of the box
the procedure for ssh is ok , the script run well and when i reboot i loose my ssh (it's normal) and the network
won't start correctly :
so i detach mu usb hdd and plug it on my netbook to see the log
it appears that eth0 is 1000Mb/s with no autoneg and my box operate at 100Mb/s
i also see eth1 (perhaps it's a virtual interface over eth0) autoneg is operationnal on eth1
i was unable to use wlan0 (i have error in the log)
to recover the network
i extract
http://archlinuxarm.org/arm/core/linux-firmware-20110822-1-any.pkg.tar.xz on my usb hdd to have all the firmware
then i add a line in rc.local
/usr/sbin/wpa_supplicant -B -i wlan0 -c /etc/wpa_supplicant.conf
the option -B run the process as demon (in the background) , thanks to igorert
and i modify /etc/wpa_supplicant.conf to reflect my box config for wifi (you must adapt for you)
network={
ssid="Livebox-xxxx"
priority=2
key_mgmt=WPA-PSK
psk=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
proto=WPA2
pairwise=CCMP
}
in rc.conf i add :
interface=wlan0
address=192.168.1.16
netmask=255.255.255.0
gateway=192.168.1.1
i plug an usb wifi key ( connectland WIRE-N-USB-R based on the rtl8712u.bin firmware)
and when i boot i have the network in archlinux with this usb wifi key on wlan0 (with this key , the internal wifi is on wlan1)
so now i can connect with ssh
i must add a route to go to the net
route add default gw 192.168.1.1 wlan0 (i don't know why rc.conf didn't do that)
pacman -Suy
and now i a on archlinux with kernel 3.0
i install nginx + pluxml and i put my blog on-line
http://pichat.fr.nfI hope this would be helpfull for those with network problem with arch on iconnect