thanks igoret
i will look
i have done some test try to map the eth1 to eth0 with mii-tool , ifconfig, changing some parameters but no result
may be if possible to map the mac address to eth1 as this one is responding better but link still nok.
What are the dmesg on a gigabit switch ?
mii-tool -v
SIOCGMIIPHY on 'eth0' failed: Operation not supported
eth1: 100 Mbit, full duplex, link ok
product info: vendor 00:50:43, model 36 rev 0
basic mode: 100 Mbit, full duplex
basic status: link ok
capabilities: 1000baseT-FD 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
[root@zigomatic ~]# ethtool eth1
Settings for eth1:
Supported ports: [ TP AUI BNC MII FIBRE ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 11
Transceiver: external
Auto-negotiation: off
Link detected: no
[root@zigomatic ~]# ethtool eth0
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: Not reported
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: Not reported
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Link detected: no