Iconnect IPv6 DHCP problem. Please Help.

[babadagi]

I'm using script and prepare usb flash for the Archlinux boot.
the device does not boot properly. i think dhcp problem, log says

Nov 3 14:22:54 alarm kernel: [ 46.347810] eth0: no IPv6 routers present

Please take a look.

everything.log is attached the message.

[WarheadsSE]

Which device is this for?

Do you have a IPv6 capable router handing out DHCPv6 addresses?

[babadagi]

for Iomega Iconnect..

and i dont have a ipv6 router..
and thank you for answer..

[WarheadsSE]

Ok, the device certainly helps, but if you don't have an IPv6 router then DHCP is going to spit out that message... until you turn off IPv6.

Also, I see this:
$this->bbcode_second_pass_code('', 'Nov 3 14:22:43 alarm kernel: [ 19.452997] NET: Registered protocol family 17
Nov 3 14:22:43 alarm kernel: [ 19.457526] Distributed Switch Architecture driver version 0.1
Nov 3 14:22:43 alarm kernel: [ 19.467859] eth0[0]: could not detect attached switch
Nov 3 14:22:43 alarm kernel: [ 19.472960] eth0[0]: couldn't create dsa switch instance (error -22)')

[babadagi]

How can I turn off dhcp?

i was edit /etc/rc.conf for static ip but not success..

edit:
i was edit modprobe.conf and disable ipv6, but nothing is change..
the device is stuck during boot process..