Migration from archlinux armv5(dockstar) to armv6(raspberry)

[atlaware]

Hi, I have an archlinuxarm installed on a dockstar (armv5), work perfect and is up to date.
In the next day I want to upgrade hardware to raspberry pi(armv6), there is some standard step for do this? (software level)
I need to change kernel? change configuration or some files in etc?

Thank You!

Atla

[pepedog]

There is no easy way to do this, and I don't know what media you have now.
The pi must boot from an sd card, 1st partition is fat32 hand has kernel and firmware. It gets mounted as /boot later.
I would get what packages are installed now (pacman -Qq), less kernel
Boot from sd card, mount old media, make a directory on it called old, move everything on it into that folder
Copy whats on second partition on card to root of old media
Edit cmdline.txt to point to old drive as rootfs
Now you start pi again with root fs on old media, update and install packages, pick an choose what data and config you want from the /old directory.
Warning, always sync before reboot, and to turn off use poweroff command

If you have a new drive for the pi that's a different story, with both running you could rsync data over the network

[atlaware]

$this->bbcode_second_pass_quote('pepedog', '
')If you have a new drive for the pi that's a different story, with both running you could rsync data over the network

[pepedog]

Carefull what you sync, no binaries and check config. Binaries are not compatable

[moonman]

What are you going to be using rpi for? if you will use it as a NAS, i would consider this as a downgrade.

You can install everything from scratch and then just copy the config files over.