Hello all,
I made a full update yesterday. In particular:
$this->bbcode_second_pass_code('', 'xorg-server (1.20.13-2 -> 21.1.1-3)')
startx now failed with Segmentation fault error.
$this->bbcode_second_pass_code('', '[ 44.296] (EE) Segmentation fault at address 0x5
[ 44.296] (EE)
Fatal server error:
[ 44.296] (EE) Caught signal 11 (Segmentation fault). Server aborting')
Am I the only one or is it a configuration issue ?
$this->bbcode_second_pass_code('', '# cat /boot/cmdline.txt
root=/dev/mmcblk0p2 rw rootwait console=serial0,115200 console=tty1 selinux=0 plymouth.enable=0 smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 kgdboc=serial0,115200 ipv6.disable=1 quiet loglevel=3')
$this->bbcode_second_pass_code('', '# cat /boot/config.txt
# See /boot/overlays/README for all available options
# Enable bluetooth
dtparam=krnbt=on
initramfs initramfs-linux.img followkernel
[pi4]
# Run as fast as firmware / board allows
arm_boost=1
# Kodi
[all]
include kodi.config.txt')
$this->bbcode_second_pass_code('', '# cat /boot/kodi.config.txt
dtoverlay=vc4-kms-v3d,cma-512
dtoverlay=rpivid-v4l2
### leave this next entry blank as ensures dt parameters like dtparam=audio=on
### which could appear after "include kodi.config.txt" in /boot/config.txt are
### applied to the base dt instead of to the last dtoverlay loaded
dtoverlay=
disable_overscan=1
disable_fw_kms_setup=1
### RPi 4B/400 ONLY
### For 4k content @ 60 Hz refresh rate, uncomment hdmi_enable_4kp60=1
#
### If it breaks video output as detailed in the following bug, also uncomment
### force_turbo=1 see: https://github.com/raspberrypi/linux/issues/4446
hdmi_enable_4kp60=1
force_turbo=1
### uncomment to use the analog audio jack
### the 2nd option prevents crackling audio when HW accel decoding is active
#dtparam=audio=on
#audio_pwm_mode=1')
Thanks for your support!