Hi, I have a RPi 4 running the ARMv7 installation.
I have a Camera Module 3 (IMX708)
I have read various guides online and I have got to the point where it says the camera is "supported" but it is not detected.
This is my config.txt
$this->bbcode_second_pass_code('', '
dtoverlay=vc4-kms-v3d
initramfs initramfs-linux.img followkernel
display_auto_detect=1
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
disable_splash=1
# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on
dtparam=audio=on
audio_pwm_mode=2
start_x=1
# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18
# Automatically load overlays for detected cameras
camera_auto_detect=1
# Uncomment to enable bluetooth
dtparam=krnbt=on
[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1
[pi4]
# Run as fast as firmware / board allows
arm_boost=1
[all]
gpu_mem=512
program_usb_boot_mode=1
over_voltage=6
arm_freq=2000
gpu_freq=750
')
I am not sure if I need to blacklist or load any modules as I couldn't find information specific to the RPi 4.
Many thanks
Mark