latest firmware CRASHES RP1

$this->bbcode_second_pass_quote('pepedog', '')$this->bbcode_second_pass_quote('', 'T')hen reinserted the Ultra sd back into the rpi booted and ran pacman -Syu, the only thing that installed was the firmware

[greenfish29]

I have the same problem. Clean SD card installation, then 'pacman -Syu' and after restart RasPi don't boot again. I try enlarge SD card partition to use all it's capacity, and after that I try 'pacman -Syu', but result is the same. Can anyone help with this issue?

Edit:
After repeating all this install and update process with --ignore raspberry-firmware, all works now. It was too raspberrypi-firmware-20121120-1. I want try Arch, before I used Raspbian, but it is very bugy. It's Arch on the same board with him?

[Magikarp]

I can confirm that there is nothing wrong with firmware or kernel. Latest versions work just fine, but post install message for firmware is still there.

[greenfish29]

$this->bbcode_second_pass_quote('Magikarp', 'I') can confirm that there is nothing wrong with firmware or kernel. Latest versions work just fine, but post install message for firmware is still there.

[pepedog]

All I can do is rebuild the 2 packages, I don't think anything magical has happened upstream, but you never know.
Also work is progressing by the foundation on 3.6 kernel and matching firmware, will knock them up and post so there is an alternative to use

[pepedog]

OK, latest kernel and firmware can be installed with pacman -Syu

[Magikarp]

I have just updated to the latest packages, and Pi is working just fine. Something is wrong on your end guys.

@pepedog, can you please post PKGBUILDs for 3.6 kernel and next firmware branch?

[greenfish29]

$this->bbcode_second_pass_quote('pepedog', 'O')K, latest kernel and firmware can be installed with pacman -Syu

[Magikarp]

Here are my files so you can compare the differences.

config.txt
$this->bbcode_second_pass_code('', '
gpu_mem=128
disable_overscan=1
hdmi_force_hotplug=1
hdmi_ignore_cec_init=1
')
cmdline.txt
$this->bbcode_second_pass_code('', '
sdhci-bcm2708.enable_llm=1 sdhci-bcm2708.sync_after_dma=0 smsc95xx.turbo_mode=N dwc_otg.lpm_enable=0 console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 console=tty1 consoleblank=0 loglevel=2 root=/dev/mmcblk0p2 rootfstype=ext4 rootwait
')
I don't know if most of the options are even necessary, but the do work.

I'm using Transcend 8GB SDHC Class10 and powered hub from modmypi.com for power and ethernet for network.

For most problems with Pi, cause is either SD or power. Have you tried any other distro?

[greenfish29]

$this->bbcode_second_pass_quote('Magikarp', '
')I don't know if most of the options are even necessary, but the do work.

I'm using Transcend 8GB SDHC Class10 and powered hub from modmypi.com for power and ethernet for network.

For most problems with Pi, cause is either SD or power. Have you tried any other distro?