ITEAD: Only gets IP if UART connected during boot

This forum is for supported devices using an ARMv7 Allwinner SoC.

ITEAD: Only gets IP if UART connected during boot

Postby kdubious » Thu Apr 07, 2016 11:06 pm

I've been testing several ITEAD boards, and may have noticed a pattern. Everything worked fine during my initial testing with a Serial USB UART attached.

However, trying to power up these device without the UART attached, they do not get an IP address. In fact, I used Wireshark on my DHCP server, and I see no DHCP traffic unless the device is powered on with the UART connected. Even connecting the UART after boot, and running
Code: Select all
ifconfig eth0 down
ifconfig eth0 up

or
Code: Select all
dhcpcd eth0

has no effect.

I'm using the mainline kernel (4.5) and mainline u-boot.

Do I have a u-boot issue? DTS? Any ideas for how to fix or how to troubleshoot?
kdubious
 
Posts: 3
Joined: Tue Dec 16, 2014 6:14 pm

Return to Allwinner

Who is online

Users browsing this forum: nezhac and 2 guests