Cubietruck &VGA

This forum is for supported devices using an ARMv7 Allwinner SoC.

Cubietruck &VGA

Postby impatt » Sat Feb 10, 2018 11:14 am

Hello everybody.
I want to run a fresh installation of ArchLinux ARM on the Cubietruck board.
I have a single monitor connected by a VGA cable.
If I do the installation of ArchLinux according to the instructions, then after starting the kernel, the signal on VGA is completely turned off. I guess Linux should clearly understand which output channel to use.
I'm using the modified boot.scr - the line is added:
$this->bbcode_second_pass_code('', 'setenv video-mode sunxi:1280x1024-24@60,monitor=vga,hpd=0,edid=1')
And also the kernel parameters string is:
$this->bbcode_second_pass_code('', 'setenv bootargs console=${console} console=tty1 root=/dev/sda1 rw rootwait')

A question: what it is necessary to change, that getty was launched on VGA-console?
impatt
 
Posts: 6
Joined: Mon Apr 27, 2015 4:41 am

Return to Allwinner

Who is online

Users browsing this forum: No registered users and 6 guests