I followed instructions on https://archlinuxarm.org/platforms/armv ... xino-micro to boot into Arch from SD card. The instructions on how to have the main system reside on SATA are not entirely clear though. The section on how to boot from SATA only mentions /dev/sdX - at what point should the system be moved on the SATA drive, which can't be accessed until the system first boots? Shouldn't there be mention of /dev/sdY for that?
With the system fully residing on the SD card, I can boot into Linux and get the following for $this->bbcode_second_pass_code('', 'fdisk -l')
$this->bbcode_second_pass_quote('', '
')Disk /dev/mmcblk0: 29.7 GiB, 31914983424 bytes, 62333952 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0xaf7f19a1
Device Boot Start End Sectors Size Id Type
/dev/mmcblk0p1 2048 62333951 62331904 29.7G 83 Linux
Disk /dev/sda: 232.9 GiB, 250059350016 bytes, 488397168 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0x6f20736b
Device Boot Start End Sectors Size Id Type
/dev/sda1 2048 34814 32767 16M 83 Linux
/dev/sda2 34816 488397167 488362352 232.9G 83 Linux