ArchLinuxARM-armv7 pack was not built in Mali module?

[Willpower]

Hi, I've started with A20-Olinuxino-Micro and officially pack at http://archlinuxarm.org/platforms/armv7 ... xino-micro.
I tried to build GUI with 2D, 3D hardware accelerator, but it seem the default kernel was not built in mali, ump, drm module.
I want to ask are there any solution to add the driver without re-compiling the kernel and modules?
I also have modules for 3.4 kernel, Arch Linux kernel is 4.1
Regard,

[sappel]

Since I'm kind of having the same question: Did you find any solution?

[sappel]

Just FYI: I recompiled the kernel from linux-sunxi (older version) since I didn't find a way to get the MALI and UMP modules into the newer ARCHLINUX kernel.

To get the linux-sunxi kernel running was a bit of work. I followed the tutorials at the linux-sunxi wiki. The basic steps were:

• do Steps 1-5 from http://archlinuxarm.org/platforms/armv7 ... bieboard-2
• cross compile the linux-sunxi kernel (I used ng-cross) http://linux-sunxi.org/Linux_Kernel#Compilation
• cross compile u-boot http://linux-sunxi.org/U-Boot
• setting up the SD card http://linux-sunxi.org/Bootable_SD_card#Bootloader (only cleaning + bootloader, not the partitioning)
• setting up boot files (copy uImage, create + copy script.bin, create + copy boot.cmd + boot.scr) http://linux-sunxi.org/Manual_build_how ... _partition
• copy modules

[sappel]

further informations:

To get fbturbo running, I did the following

• install libump follwing this guide http://linux-sunxi.org/Mali_binary_driver
• install libdri2 (see link above)
• install sunxi-mali
• install xorg-server-devel (needed for the next step)
• further following this guide for (partial) 3d accel: http://linux-sunxi.org/Xorg#fbturbo_driver

I hope I got all the steps. It was quite a mess with a lot of trial+error...