Hello all,
I am new to the forum, but an above average novice (perhaps intermediate?) user of Arch Linux and have built a few desktops successfully utilizing the distro. I recently acquired a Udoo Quad and naturally wanted to continue with Arch as I am most familiar with it and would be doing a fair bit of development utilizing a few third-party packages. Anywho, I have followed the installation instructions at:
https://archlinuxarm.org/platforms/armv7/freescale/udoo
on a few different occasions and have attempted to research and find any bugs or exceptions to the instruction that is listed and I am stumped.
This is the output from minicom during power on. I am utilizing Arch Linux x86_64 hosted on an HP Pavilion dv7 Notebook w/ Kernel: 4.15.3-1-ARCH to do the configuration and install. The MMC is read via a built-in card reader with the address mmcblk0. I am stumped.
Any ideas?
Kindest Regards,
RiLL
$this->bbcode_second_pass_code('', 'Welcome to minicom 2.7.1
OPTIONS: I18n
Compiled on Apr 20 2017, 07:07:53.
Port /dev/ttyUSB0, 23:15:56
Press CTRL-A Z for help on special keys
U-Boot SPL 2016.11-1 (Nov 19 2016 - 13:10:56)
Trying to boot from MMC1
U-Boot 2016.11-1 (Nov 19 2016 - 13:10:56 -0700) Arch Linux ARM
CPU: Freescale i.MX6Q rev1.5 at 792 MHz
Reset cause: POR
Board: Udoo Quad
DRAM: 1 GiB
MMC: FSL_SDHC: 0
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: using phy at 6
FEC [PRIME]
Hit any key to stop autoboot: 0
switch to partitions #0, OK
mmc0 is current device
SD/MMC found on device 0
** No partition table - mmc 0 **
Checking for: /uEnv.txt ...
** No partition table - mmc 0 **
Loading /boot/zImage..
** No partition table - mmc 0 **
No kernel found
=>
')