Udoo support

[stramuort]

Udoo is a Freescale i.MX 6 board very similar to Wandboard with an integrated Arduino microcontroller: http://www.udoo.org/features/.

Do you think the Wandboard image could run on Udoo with little/no tweaking?

[schuschu]

I just booted up using the "generic" imx6 rootfs and the official udoo modules and uImage. Some tinkering was required but so far it runs fine (not tested much, only serial/graphical console, twm). I will go on and test a few more things but since there is a linux-udoo package so official support should not be far away.

schuschu

[kmihelich]

Official support has been finalized now that they released their U-Boot source code so I could get things working the way I like to see them. Since being limited to ext3 is a little insane these days, I also patched in ext4 support and that is the default for our setup. Support for a boot.scr under /boot is also there to make modifications without going into U-Boot over serial. The kernel has also been updated to their latest sources.

Installation instructions:
http://archlinuxarm.org/platforms/armv7/freescale/udoo

[Phatdaro]

Would it be possible to add kernel modul for Prolific PL2303?
Or can you give informations on how to add kernel module to a linux/Arch beginner?