Hello,
I tried to go on a kernel update from 3.0.35 to 3.10.xx-dt on my Utilite. The uboot I have put on the new stand according to the instructions in Utilitewiki. I now get the following error when booting ...
U-Boot SPL 2014.10-cm-fx6-2.1 (Jan 19 2015 - 11:28:10)
Trying to boot from MMC
Card did not respond to voltage select!
spl: mmc_init failed: err - -17
Trying to boot from SPI
U-Boot 2014.10-cm-fx6-2.1 (Jan 19 2015 - 11:28:10)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: CM-FX6
I2C: ready
DRAM: 2 GiB
NAND: 0 MiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
SF: Detected M25PX16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB
In: serial
Out: serial
Err: serial
Net: FEC
Hit any key to stop autoboot: 0
Card did not respond to voltage select!
Card did not respond to voltage select!
AHCI 0001.0300 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part
SATA Device Info:
S/N: 132972401252
Product model number:
Firmware version:
Capacity: 62533296 sectors
reading boot.scr
308 bytes read in 128 ms (2 KiB/s)
Running bootscript from sata ...
## Executing script at 10800000
SATA device 0: Model: Firm: Ser#: 132972401252
Type: Hard Disk
Supports 48-bit addressing
Capacity: 30533.8 MB = 29.8 GB (62533296 x 512)
... is now current device
reading uImage
** Unable to read file uImage **
## Booting kernel from Legacy Image at 10800000 ...
Image Name: Utilite boot
Created: 2015-02-06 22:52:49 UTC
Image Type: ARM Linux Script (uncompressed)
Data Size: 244 Bytes = 244 Bytes
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 236 Bytes = 236 Bytes
Verifying Checksum ... OK
Wrong Image Type for bootm command
ERROR: can't get kernel image!
CM-FX6 #
Regards Ralix