Hi there,
I have spent some time searching and can't find anything about this. Since last pacman -Syu, my USB to serial adapter does not longer show in /dev/ as ttyUSB*. It does however show as usbdev*.*. This is probably just my lack of experience, but could someone help me please?
dmesg:
$this->bbcode_second_pass_quote('', '[') 0.663299] usb 1-1: new full-speed USB device number 2 using musb-hdrc
[ 0.804046] usb 1-1: New USB device found, idVendor=067b, idProduct=2303
[ 0.804077] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 0.804107] usb 1-1: Product: USB-Serial Controller D
[ 0.804107] usb 1-1: Manufacturer: Prolific Technology Inc.
Bone: USB-to-serial recognised but not attached by udev
1 post
• Page 1 of 1
Bone: USB-to-serial recognised but not attached by udev
by alien » Wed Jun 27, 2012 9:55 pm
lsusb:
$this->bbcode_second_pass_quote('', 'B')us 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 002: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port
usb-devices:
$this->bbcode_second_pass_quote('', 'T'): Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=480 MxCh= 1
D: Ver= 2.00 Cls=09(hub ) Sub=00 Prot=01 MxPS=64 #Cfgs= 1
P: Vendor=1d6b ProdID=0002 Rev=03.02
S: Manufacturer=Linux 3.2.18-1 musb-hcd
S: Product=MUSB HDRC host driver
S: SerialNumber=musb-hdrc.1
C: #Ifs= 1 Cfg#= 1 Atr=e0 MxPwr=0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=067b ProdID=2303 Rev=04.00
S: Manufacturer=Prolific Technology Inc.
S: Product=USB-Serial Controller D
C: #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA
I: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=00 Driver=(none)
- alien
- Posts: 1
- Joined: Wed Jun 27, 2012 9:06 pm