[SOLVED] BBB: Can't connect to the board via SSH.

This forum is for supported devices using an ARMv7 Texas Instruments (TI) SoC.

[SOLVED] BBB: Can't connect to the board via SSH.

Postby mariusmmg2 » Fri May 20, 2016 2:31 pm

Hi,

I have booted up Arch Linux distribution on my BeagleBone Black, but now I can't connect to the board using SSH :cry:

Is SSH enabled by default in archlinux? If no, how can I connect to the board? (to do some initial setup: install SSH, install WiFi drivers, etc).

I have also tried to chroot into the distro that is on SD card, but it gives me "chroot: failed to run command `/bin/bash': No such file or directory".

Any ideas?
Last edited by mariusmmg2 on Fri May 20, 2016 4:00 pm, edited 1 time in total.
mariusmmg2
 
Posts: 10
Joined: Thu May 19, 2016 9:23 am

Re: BBB: Can't connect to the board via SSH.

Postby mariusmmg2 » Fri May 20, 2016 3:59 pm

nMap haves a very strange way of showing nodes in a network :))
I was trying to connect to the board using another IP, using the right address solved the problem.
mariusmmg2
 
Posts: 10
Joined: Thu May 19, 2016 9:23 am


Return to Texas Instruments (TI)

Who is online

Users browsing this forum: No registered users and 6 guests