Hi,
is the C3 supported at all?
The u-boot in http://os.archlinuxarm.org/os/ArchLinux ... est.tar.gz doesn't work on it (most likely because of changes between C4 and C5) so I had to build from source with the required patches.
The default bootcmd doesn't play well so I updated it as so:
setenv bootargs "console=${console} vram=${vram} rootfstype=ext4 root=/dev/mmcblk0p2 rootwait rw"
setenv bootcmd 'run findfdt; load mmc 0:1 ${fdtaddr} /dtbs/${fdtfile}; load mmc 0:1 ${loadaddr} /zImage; bootz ${loadaddr} - ${fdtaddr}'
But all I get is
reading /dtbs/omap3-beagle.dtb
107229 bytes read in 24 ms (4.3 MiB/s)
reading /zImage
5085296 bytes read in 379 ms (12.8 MiB/s)
## Flattened Device Tree blob at 88000000
Booting using the fdt blob at 0x88000000
Loading Device Tree to 8ffe2000, end 8ffff2dc ... OK
Starting kernel ...
And then nothing. Unless the console has changed? This is what I've got, can anyone confirm that theirs is the same?
console=ttyO2,115200n8
I've also tried fatload since it is loading the dtb and zImage off my FAT16 partition but it's the same.
Any way to get this to work?
Thank you.