installation on eMMC

Hi guys its my first post but, I followed this how-to http://archlinuxarm.org/platforms/armv7 ... bone-black
and everything were fine except installation on eMMC.

$this->bbcode_second_pass_quote('', 'A')fter booting into Arch Linux ARM, follow the above steps 4 through 7 using the device /dev/mmcblk1p[1|2]. Repartitioning is not required since the eMMC is already partitioned correctly.

[WarheadsSE]

wget => curl

At worst, install as necessary from pacman.

[nextuser]

ah, I installed needed packages like normall arch linux, and everything works now

$this->bbcode_second_pass_quote('', 'P')ower down the system, waiting until all the LEDs go out:poweroff
Remove power, remove the micro SD card, then reapply power. The system will boot into eMMC. If an SD card created with the above steps is still in the system when it boots, it will boot to the SD card instead of eMMC.