Hi all. I've bought cheap NAS from seagate. I bought it without HDD. After few hours of searching i've found partition structure (yes NAS has whole os on drive) and recreated the original firmware on custom HDD. It's booting fine and working, but that's a little crappy OS inside I'd preffer arch linux in it. Can you help me with building?
Here's info about structure:
$this->bbcode_second_pass_code('', '
root@NAS:/home/upgreydd# cat /proc/cpuinfo
Processor : ARMv6-compatible processor rev 4 (v6l)
BogoMIPS : 279.34
Features : swp half thumb fastmult vfp edsp java
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xb02
CPU revision : 4
Hardware : Cavium Networks CNS3420 Validation Board
Revision : 0000
Serial : 0000000000000000
root@NAS:/home/upgreydd# free
total used free shared buffers
Mem: 254208 232896 21312 0 12800
Swap: 0 0 0
Total: 254208 232896 21312
')
I have original rootfs (squashfs and extracted) and uImage. Is there some getting started guide? I've found serial at board (RX, TX). any advice please?