Zyxel NSA325 won't start after installation

This forum is for Marvell Kirkwood devices such as the GoFlex Home/Net, PogoPlug v1/v2, SheevaPlug, and ZyXEL devices.
Topic locked

Re: Zyxel NSA325 won't start after installation

Postby viliamjobko » Fri Dec 06, 2013 3:42 pm

Hello all,
I had recieved TTL<->USB cable and succesfully restored the device with "run to_stock" command.

Also, I was able to install archlinuxarm and I'm now focusing to customize it.

Thank you :D
viliamjobko
 
Posts: 3
Joined: Sun Oct 27, 2013 12:25 am
Top

Re: Zyxel NSA325 won't start after installation

Postby WarheadsSE » Fri Dec 06, 2013 7:50 pm

:)
Core Developer
Remember: Arch Linux ARM is entirely community donation supported!
WarheadsSE
Developer
 
Posts: 6807
Joined: Mon Oct 18, 2010 2:12 pm
Top

Re: Zyxel NSA325 won't start after installation

Postby sirkkalap » Mon Dec 30, 2013 10:50 pm

I am in the same situation here. About every 20 second the NSA325 just reboots. I wonder if it is possible to run the "run to_stock" command using just the installation USB-stick. Possibly by editing the usb_key_func.sh.2 script?
sirkkalap
 
Posts: 1
Joined: Mon Dec 30, 2013 5:35 pm
Top

Re: Zyxel NSA325 won't start after installation

Postby WarheadsSE » Tue Dec 31, 2013 2:18 am

It has to boot for that stick to do anything. So no.
Core Developer
Remember: Arch Linux ARM is entirely community donation supported!
WarheadsSE
Developer
 
Posts: 6807
Joined: Mon Oct 18, 2010 2:12 pm
Top

Re: Zyxel NSA325 won't start after installation

Postby EnteEnteEnte » Thu Jan 23, 2014 1:13 am

Thx for post and pics :very helpful! But in my setup i had to swap rx and tx.
EnteEnteEnte
 
Posts: 1
Joined: Thu Jan 23, 2014 1:06 am
Top
Previous
Topic locked

Return to Marvell Kirkwood

Who is online

Users browsing this forum: No registered users and 6 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group    © Arch Linux ARM