I dusted off my GoFlex Home yesterday after some 7 years in storage and messed up: after getting it to boot the first time (it acquired a DHCP lease) but unable to SSH into it I just switched it off and now it doesn't even get an IP address anymore.
Assuming I may have messed up the filesystem I shucked its HDD, hooked it up to my PC, formatted/partitioned/extracted the latest base image to the first ext3 partition following the spirit of the instructions here.
Still no boot.
Is there any way of unbricking the thing that doesn't require soldering at this point?
I remember following the instructions on the ArchLinux ARM website (likely the same page) back in the day to get it installed in the first place.