Hi,
i bought a pci lpt card, but it still doesnt work.
I tried it with srst connected without it, with vcc and with out.
How do i see if the
jtag is working or where to search for errors?
is this port setting correct?
io range d880-d887
d800-d807
$this->bbcode_second_pass_quote('', 'C'):\Documents and Settings\Administrator>openocd -f board/dockstar.cfg
Open On-Chip Debugger 0.4.0 (2010-02-22-19:05)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.berlios.de/doc/doxygen/bugs.htmlparport port = 0x378
trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain
jtag_nsrst_delay: 200
jtag_ntrst_delay: 200
Warn : use 'feroceon.cpu' as target identifier, not '0'
Info : clock speed 500 kHz
Error:
JTAG scan chain interrogation failed: all zeroes
Error: Check
JTAG interface, timings, target power, etc.
Error:
JTAG scan chain interrogation failed: all zeroes
Error: Check
JTAG interface, timings, target power, etc.
Command handler execution failed
Warn :
jtag initialization failed; try '
jtag init' again.
Info : accepting 'telnet' connection from 0
Error: Target not examined yet
Command handler execution failed
Info : Embedded ICE version 0
Info : feroceon.cpu: hardware has 1 breakpoint/watchpoint unit
Error: unexpected Feroceon EICE version signature
Warn : target was in unknown state when halt was requested
Info : Halt timed out, wake up GDB.
Error: timed out while waiting for target halted
Command handler execution failed
Info : Halt timed out, wake up GDB.
Error: timed out while waiting for target halted
Command handler execution failed
Error: unexpected Feroceon EICE version signature
Info : Halt timed out, wake up GDB.
Error: timed out while waiting for target halted
Command handler execution failed