Pogoplug Mobile and Archlinux

[regder]

Has anyone gotten this to work? I see the V4 is supported, but can't find anything specific to the Mobile

Appreciate any help

[regder]

I guess it isn't supported then, followed the instructions for V4 and now I'm stuck with the blinking green light of death. Back to the store it goes.

[WarheadsSE]

You give up too easily.

This has worked for several people.

[regder]

Trust me, I would love to get this to work, doesn't look like it's going to happen though.

Too bad, was able to pick it up for $30 on sale

[WarheadsSE]

It ought to work off the USB 2.0 ports. Odd. Try redoing your rootfs (remember, ext3**).

[kmihelich]

Ext3 is actually the way to go, not ext2. That's what I set up for in U-Boot.

Just try a different install drive, and you can always revert. See the Advanced tab for its page on the main site.

[regder]

Tried again, no go, can't even revert back to the original pogo software. Perhaps it's because there's only one usb port on the device?

[kmihelich]

No. All you need is a normal FAT32-formatted usb drive, and create a folder named revert on it. Plug it in and then plug in the power, the device will go back to stock.

[regder]

Doesn't seem to be working for me then. I'm using a brand new flash drive that looks like this, https://lh5.googleusercontent.com/-HLTK ... 2520PM.jpg

[kmihelich]

If you installed following the V4 instructions on our site, there isn't any reason for it not to work.