ok more reading
more wasted weekend
i have read jeffs and the other guides out there
i can read the boot from a linux terminal netconsole
but following all the instructions
i carnt get it to boot from anything ubs or harddrive
comes up with error like this about block error
sorry about the formating is was pasted into something first that screwed formating
$this->bbcode_second_pass_code('', 'U-Boot 2010.09 (Feb 16 2011 – 18:44:23)
UBIT v0.6 by Jeff Doozan and Peter Carmichael (Re)start USB…
USB:Register 10011 NbrPorts 1
USB EHCI 1.00 scanning bus for devices…
2 USB Device(s) found scanning bus for storage devices…
1 Storage Device(s) found
Hit any key to stop autoboot:
0 UBIFS error (pid 0):
ubifs_get_sb:
cannot open “ubi:fast”, error -19 Error reading superblock on volume ‘ubi:fast’!
UBIFS not mounted, use ubifs mount to mount volume first!
Loading file “/boot/uImage” from usb device 0:1 (usbda1)
Failed to mount ext2 filesystem… **
Bad ext2 partition or disk – usb 0:1 **
Loading file “/uInitrd” from usb device 0:1(usbda1)
Failed to mount ext2 filesystem… **
Bad ext2 partition or disk – usb 0:1 **
reading /boot/uImage
** Unable to read “/boot/uImage” from usb 0:1 ** reading /uInitrd
** Unable to read “/uInitrd” from usb 0:1 ** **
Block device usb 1 not supported **
Block device usb 1 not supported
** Invalid boot device **
** Invalid boot device ** **
Block device usb 2 not supported **
Block device usb 2 not supported
** Invalid boot device **
** Invalid boot device ** **
Block device usb 3 not supported **
Block device usb 3 not supported
** Invalid boot device **
** Invalid boot device **
Reset IDE: Bus 0:
OK Bus 1: not available Device 0: Model: ST32000542AS Firm: CC95 Ser#: 5XW132TA Type: Hard Disk Supports 48-bit addressing Capacity: 1907729.0 MB = 1863.0 GB (-387938128 x 512) Loading file “/boot/uImage” from ide device 0:1 (hda1) ** ext2fs_devread() read outside partition sector -844890096 ** File not found /boot/uImage Loading file “/uInitrd” from ide device 0:1 (hda1) 4005544 bytes read UBIFS error (pid 0): ubifs_get_sb: cannot open “ubi:boot”, error -19 Error reading superblock on volume ‘ubi:boot’! UBIFS not mounted, use ubifs mount to mount volume first! reading /boot/uImage
** Unable to read “/boot/uImage” from ide 0:1 ** reading /uInitrd
** Unable to read “/uInitrd” from ide 0:1 **
** Bad partition 1 **
** Bad partition 1 **
No Powersaving mode 7F Error (no IRQ) dev 1 blk 0: status 0x7f
** Can’t read from device 1 **
** Unable to use ide 1:1 for fatload
** No Powersaving mode 7F Error (no IRQ) dev 1 blk 0: status 0x7f
** Can’t read from device 1 **
** Unable to use ide 1:1 for fatload
** UBIFS error (pid 0): ubifs_get_sb: cannot open “ubi:ramdisk”, error -19
Error reading superblock on volume ‘ubi:ramdisk’!
UBIFS not mounted, use ubifs mount to mount volume first!
Marvell>>')
its a 2tb Brick