I have a Seagate GoFLEX Home running on ALARM. My ISP, Comcast, has provided IPv6. However, my GoFLEX Home only has been assigned with a private IPv4 address. Does ALARM support IPv6? If so, what kernel packages should I install?
FYI, uname -a output as follows:
$this->bbcode_second_pass_code('', '[root@alarm ~]# uname -a
Linux alarm 3.18.5-1-ARCH #1 PREEMPT Sat Jan 31 02:35:20 MST 2015 armv5tel GNU/Linux
[root@alarm ~]# ')
Enabling IPv6
4 posts
• Page 1 of 1
Enabling IPv6
by habibie » Fri Mar 06, 2015 4:10 pm
- habibie
- Posts: 28
- Joined: Sun Nov 04, 2012 11:55 am
Re: Enabling IPv6
by WarheadsSE » Fri Mar 06, 2015 5:31 pm
It should be supported. Did you set it up to get an IPv6 DHCP ?
- WarheadsSE
- Developer
- Posts: 6807
- Joined: Mon Oct 18, 2010 2:12 pm
Re: Enabling IPv6
by moonman » Sat Mar 07, 2015 12:58 am
Mine gets ipv6 address automatically. Does your router do stateless or stateful advertising. Stateless works out of the box
Pogoplug V4 | GoFlex Home | Raspberry Pi 4 4GB | CuBox-i4 Pro | ClearFog | BeagleBone Black | Odroid U2 | Odroid C1 | Odroid XU4
-----------------------------------------------------------------------------------------------------------------------
[armv5] Updated U-Boot | [armv5] NAND Rescue System
-----------------------------------------------------------------------------------------------------------------------
[armv5] Updated U-Boot | [armv5] NAND Rescue System
- moonman
- Developer
- Posts: 3388
- Joined: Sat Jan 15, 2011 3:36 am
Re: Enabling IPv6
by habibie » Sat Mar 07, 2015 1:13 am
I took a look at the cable modem unit and the IPv6 is configured as a Stateless (Auto-Config). Also, if I reboot my GoFLEX Home into OpenWRT, it is capable of IPv6, i.e. assigned with a public IPv6 address by the cable modem unit. Perhaps, my ALARM is missing some packages that support IPv6?
- habibie
- Posts: 28
- Joined: Sun Nov 04, 2012 11:55 am
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 37 guests