Greetings,
When I purchased my dockstar, I was sent a dud, and then a working one. I was allowed to keep the dud. I got to thinking however, that it might be possible to fix it. After hacking together a serial cable and connecting it I can see that it fails to boot on: Verifying Checksum ... Bad Data CRC
Reading through various forums, it seems that I need to reflash the unit. However, I can't seem to find the proper files to make the attempt. The ones mentioned at http://Arch Linux ARM.com/index.php5?title=Ha ... Reflashing either don't exist or I don't have permission to access. Can anyone recommend a location to find the files? Barring that, could anyone give any guidance on how to extract the files from my working dockstar?
My thanks in advance.
I provide the output of the failed boot below just in case anyone is interested.
U-Boot 1.1.4 (Jul 16 2009 - 21:02:16) Cloud Engines (3.4.16)
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 00690D60
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 128MB
DRAM Total size 128MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:256 MB
CPU : Marvell Feroceon (Rev 1)
CLOUD ENGINES BOARD: REDSTONE:1.0
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x100000, size 0x300000
Reading data from 0x3ff800 -- 100% complete.
3145728 bytes read: OK
## Booting image at 00800000 ...
Image Name: Linux-2.6.22.18
Created: 2009-08-31 23:31:05 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1976384 Bytes = 1.9 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC