POGO-B01 post install issues
12 posts
• Page 2 of 2 • 1, 2
Re: POGO-B01 post install issues
by WarheadsSE » Thu Sep 20, 2012 5:17 pm
Is it connected via SATA, or USB?
- WarheadsSE
- Developer
- Posts: 6807
- Joined: Mon Oct 18, 2010 2:12 pm
Re: POGO-B01 post install issues
by Socaltom » Thu Sep 20, 2012 9:07 pm
If you have a Sata drive, then your best bet is to make a small primary partition on the SATA drive. Extract the file system to that partition on the SATA drive and let it boot from there.
The B01 will try and boot from the SATA drive first, its probably hanging because it cant find the OS on the SATA.
The Oxnas systems can be a little picky about where it boots from. The configuration that was most reliable for me is, Boot from Small Sata partition. With it booting from SATA it usually boots fine with USB drives plugged in. I have not gotten a good boot from a USB with the SATA plugged in.
Tom
The B01 will try and boot from the SATA drive first, its probably hanging because it cant find the OS on the SATA.
The Oxnas systems can be a little picky about where it boots from. The configuration that was most reliable for me is, Boot from Small Sata partition. With it booting from SATA it usually boots fine with USB drives plugged in. I have not gotten a good boot from a USB with the SATA plugged in.
Tom
used to be owned by me
Pink Pogo V2, Black Pogo V3, Zyxel NAS 325 v1,
used to be Adminstrator for
Goflex net, Black V3, Black V2
Now I have a couple of raspberry pi ( 3+ and 4)
Pink Pogo V2, Black Pogo V3, Zyxel NAS 325 v1,
used to be Adminstrator for
Goflex net, Black V3, Black V2
Now I have a couple of raspberry pi ( 3+ and 4)
- Socaltom
- Posts: 571
- Joined: Thu Apr 07, 2011 2:21 pm
- Location: The left side
12 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 43 guests