pogo pro v3 won't start after upgrading

This forum is for all other ARMv5 devices

pogo pro v3 won't start after upgrading

Postby ahmao » Fri Nov 25, 2016 7:50 pm

I was using a tftp server to download uImage during bootup.
right now looks the kernel version is out of date.

## Booting image at 60500000 ...
Image Name: Linux-2.6.31.6_SMP_820
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2132260 Bytes = 2 MB
Load Address: 60008000
Entry Point: 60008000
Verifying Checksum ... OK
OK

Starting kernel ...

Uncompressing Linux................................................................................................................................. done, booting the kernel.
[ 0.000000] Linux version 2.6.31.6_SMP_820 (root@ProDev) (gcc version 4.6.0 20110429 (prerelease) (GCC) ) #99 SMP Sun May 29 03:04:43 EDT 2011
[ 0.000000] CPU: ARMv6-compatible processor [410fb025] revision 5 (ARMv7), cr=00c5387f
[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
[ 0.000000] Machine: Oxsemi NAS


INIT: version 2.88 booting
[FAIL] udev requires a kernel >= 2.6.32, not started ... failed!
failed!


[....] Configuring network interfaces...[ 34.980000] eth0: PHY is Realtek RTL8211D, type 0x001cc914
[ 34.990000] CoPro offload is active on eth0
[ 34.990000] Alloc'ing ARM descs 8192 bytes
[ 35.000000] Alloc'ing CoPro parameters 36 bytes
[ 35.000000] gmac gmac.0: firmware: requesting gmac_copro_firmware
[ 95.010000] open() eth0: Failed to load CoPro firmware

do you know how can I get kernel and gmac updated?
and where can I get latest working uImage?
ahmao
 
Posts: 10
Joined: Sun Oct 23, 2011 5:47 pm

Return to Community Supported

Who is online

Users browsing this forum: No registered users and 3 guests