Folks,
I totally bricked my black Pogoplug pro R2E2 ??
black case, PLX chip (dualcore), sata + 3 + 1 USB.
I made a mistake, bootloader is probably totally broken.
No problem, I thought....
Just order a JST cable and put the bootloader back...
I tried with a2 cables (gnd = black, TX=white, TX= blue)
cables work, I guess. If I shortcut TX and RX, I can type in the terminal (echo effect)
The PogoPlug Pro board has a 4 pin connector.
If you can read the J3 on the left of the connector, from left to right: GND/ RX / TX ??
I hope this is correct.
I measured 3.3V between GND and RX / TX
Pin 4 is a VDD ??
I did not used it.
The bleu led besides the PLX chip shines steady.
When I connect, nothing on the terminal..
I used screen, minicom, picocom...
Is this board totally bricked ? or am I doing somthing really wrong....
Johan, a new plugpc-guy from Belgium....