Hi there,
I'm a bit of a newb to archlinux. So i tried installing it on a 500meg usb stick attached to my pogoplug pro as instructed here: http://archlinuxarm.org/platforms/armv6/pogoplug-provideov3
Well, when I rebooted after the install was finished with the output shown below from the blparam, I wasn't able to ssh into the device. So I (stupidly) decided to just reformat the usb drive, assuming all would just go back to normal, and now all my pogoplug pro does is blink green wildly without actually booting.
Any help would be really appreciated.
Thanks.
$this->bbcode_second_pass_quote('', '#') NEW uBoot Parameters
# = bootargs_usb : root=/dev/sda1 ubi.mtd=2,512 rootfstype=ext3 console=ttyS0,115200 elevator=cfq mac_adr=0x00,0x30,0xe0,0x00,0x00,0x01 mem=128M poweroutage=yes rootdelay=15
# = load_custom_nand : nboot 60500000 0 500000
# = rootfs : /dev/sda1
# = root fs type : ext3
#
# Setting up uboot parameters
#
# Checking uboot parameters...
# = bootargs_stock : root=ubi0:rootfs ubi.mtd=2,512 rootfstype=ubifs console=ttyS0,115200 elevator=cfq mac_adr=0x00,0x30,0xe0,0x00,0x00,0x01 mem=128M poweroutage=yes
# = bootargs : root=/dev/sda1 ubi.mtd=2,512 rootfstype=ext3 console=ttyS0,115200 elevator=cfq mac_adr=0x00,0x30,0xe0,0x00,0x00,0x01 mem=128M poweroutage=yes rootdelay=15
# = load_custom_nand : nboot 60500000 0 500000
# = boot_custom : run load_custom_nand boot || run load_custom_nand2 boot
#############################
## Looks good!
# Sync ...
# Unmount
# Reboot to enter into Arch Linux ARM