Hi all,
I've been running my pogoplug off a sata->esata 2.5" enclosure for a few months, but now in interest of having less "clutter", I'd like to move the 2.5" sata drive inside the pogoplug itself instead of in an external enclosure and using esata. While it's a 5400 drive, and it seems that it would (barely) fit underneath the main board in the pogoplug, any thoughts as to whether it would generate too much heat? Has anyone else done this and can report on the heat situation? (I realize I could swap it out for a SSD which would produce less (minimal) heat and even be thinner (depending on which I'd get), but I'd rather not invest the $ for SSD when 2.5" HDDs are incredible cheap (especially when I already have one I'm using!)
(if nothing else, I realize I could just "attach" the enclosure to the side of the pogoplug by rubber bands, screws, etc, but I'd rather not go down that route )
thanks for any advice!