At Installation: -sh: wget: not found

[mandozza]

At installation I got a problem.

After:

wget http://archlinuxarm.org/os/pogoplug/mke2fs

I got the message: -sh: wget: not found

What to do?

[WarheadsSE]

try $this->bbcode_second_pass_code('', 'busybox wget ...')

[mandozza]

Thanks a lot for the quick response.

Now I got after:

./mke2fs -j /dev/sda1


I got the message:

/dev/sda1 is mounted; will not make a filesystem here!

What to do?

[WarheadsSE]

You obviously skipped a step.

[mandozza]

Yes you're right - I restart the pogoplug and do it again.

Now it works until:

/tmp # ./oxnas-install.sh

The output is:

#############################
##
## Pogoplug OXNAS based boards
## Arch Linux ARM rootfs Installer
##
#############################
##
## For use with OXNAS 7820 only.
##
#############################
## PREPARATION
# Switching to /tmp...
# Ensuring we're ready to proceed...
killall: hbwd: no process killed
umount: can't umount /dev/sda1: Invalid argument
# Preparing our way...
# Getting uboot parameters...
# = MAC : 00:25:31:01:C4:96
# = load_nand : nboot 60500000 0 200000
# = bootargs : root=ubi0:rootfs ubi.mtd=2,512 rootfstype=ubifs console=ttyS0,115200 elevator=cfq mac_adr=0x00,0x30,0xe0,0x00,0x00,0x01 mem=128M poweroutage=yes
# = board : PPRO1
#
# Checking board revision...
# board has PCI: 1
#
# Deriving boot partition format...
# = PARTITION: /dev/sda1
# = FMT : ext3
#
#############################
## RETRIEVING FILES
# Downloading ArchLinuxARM-oxnas-rootfs...(approx. 138MB)
./oxnas-install.sh: line 86: wget: not found
./oxnas-install.sh: line 87: wget: not found
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
DOWNLOAD FAILED
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

What to do now?

And thanks for the very quick response

[WarheadsSE]

You're likely going to have to make some edits to the file to reflect the missing symlink, or make the symlink as necessary.

[mandozza]

So I downloaded the install script. Change the two lines with "wget ..." to "busybox wget..." and copied the script via scp.

Then chmod 755 and run the new script.

And is running!

Now I am in the updating part.

Thanks a lot!