I had a power cut, Pogoplug boots with flashing green then goes blank.
Followed the instructions on the installation page and got to
$this->bbcode_second_pass_code('', '
If your Pogoplug boots and the front LED blinks wildly for about 15-20 seconds and then TURNS OFF, you're in business when it comes to booting, but there is likely something that has stopped the network. It's not a brick, but be ready to troubleshoot.
')
I downloaded the file system from the link here http://archlinuxarm.org/platforms/armv6 ... provideov3
I have ensured it has a mac_addr file, but when the led goes out I have nothing.
My router shows no dhcp address is assigned to the mac address in the file.
Could someone point me in the correct direction of further troubleshooting steps, most things I have turned up assume some level of access to the device, or at the very least it picks up network.