by silverD » Fri Nov 15, 2013 1:02 am
So I'm now using a laptop hard drive powered from a 5v wall wart and have it connected directly to the sata port in the plug. I built the drive following the thread instructions and also ran dd to copy the uImage.nopci.
Here is what I get from serial:
$this->bbcode_second_pass_code('', 'Stage-1 Bootloader Mon Nov 14 22:36:34 EST 2011
Attempting to set PLLA to 850MHz ...
plla_ctrl0 : 0x0000020A
plla_ctrl1 : 0x00330000
plla_ctrl2 : 0x0065008B
plla_ctrl3 : 0x000000F1
PLLA Set
Setup memory, testing
Reading disk 0, Image 0
Sector : 0x0000009A
Hdr len: 0x0001FB34
Hdr CRC: 0x2229BDCD
OK
Initialising disks
SATA PHY not ready for device 1
Detecting SATA busses:
Bus 0: Found first device OK
Device 0: Model: WDC WD1200BEVT-00A23T0 Firm: 01.01A01 Ser#: WD-WXK1A30Y3522
Type: Hard Disk
Capacity: 114473.4 MB = 111.7 GB (234441648 x 512)
Device 1: not available
Failed to read valid environment from disk, using built-in default
U-Boot 1.1.2 (Dec 31 2011 - 15:24:45)
U-Boot code: 60E00000 -> 60E1FB34 BSS: -> 60E5435C
RAM Configuration:
Bank #0: 60000000 128 MB
SRAM Configuration:
64KB at 0x50000000
NAND:128 MiB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Setting Linux mem= boot arg value
IDE read: device 0 block # 288, count 1 ... 1 blocks read: OK
Hit any key to stop autoboot: 0
Loading from IDE device 0, partition 1: Name: hda1
Type: U-Boot
Image Name: Linux-2.6.31.6_SMP_820
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2288744 Bytes = 2.2 MB
Load Address: 60008000
Entry Point: 60008000
## Booting image at 60500000 ...
Image Name: Linux-2.6.31.6_SMP_820
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2288744 Bytes = 2.2 MB
Load Address: 60008000
Entry Point: 60008000
Verifying Checksum ... Bad Data CRC
Loading from IDE device 0, partition 2: Name: hda2
Type: U-Boot
** Bad Magic Number **
Unknown command 'lightled' - try 'help'
')
Is my rootfs bad? Thanks for any insight,
Nate