Hello,
I followed the "Install" instructions on the following page word for word 3 times using 2 different USB Armory devices.
https://archlinuxarm.org/platforms/armv ... usb-armory
1. I then put the SD Card into the USB armory
2. I disconnect my Arch Linux laptop from my home network because it also uses the 10.0.0.0/24 network
3. I open terminal on Arch Linux laptop and run the command `dmesg -w`
4. I plugged the USB Armory into my Arch Linux laptop
5. I see the dmesg message "cdc_ether 2-2:1.0 enp0s20u2: renamed from usb0" followed by three lines of "cdc_ether 2-2:1.0 enp0s20u2: kevent 12 may have been dropped"
6. The USB Armory now has it's LED going "blink, blink, blink"
7. I then run the command `ip addr add 10.0.0.1/24 dev enp0s20u2`
8. I then see the dmesg message "IPv6: ADDRCONF(NETDEV_UP): enp0s20u2: link is not ready" followed by one line of "cdc_ether 2-2:1.0 enp0s20u2: kevent 12 may have been dropped"
9. The USB Armory still has it's LDE going "blink, blink, blink"
10. I then run the command `ping 10.0.0.1`
11. I then get the response that the destination is unreachable
This happens with both of my USB Armory devices. I am following the instructions to the letter, and not modifying anything in the default install .tar.gz. The fact that the LED just goes "blink, blink, blink" makes me think it is not booting correctly, however the USB Ethernet devices is being activated so the Linux kernel _must_ be being successfully loaded?
What do you think could be going wrong?
I have no idea what could be the problem. It is almost like the image http://os.archlinuxarm.org/os/ArchLinux ... est.tar.gz may be broken.