dongle 4G (hub powered) fixing recursive fault but reboot ..

[acconciox]

dongle 4G (hub powered) fixing recursive fault but reboot is needed. (raspberry pi 3b)

The first boot always fails, no matter i wait before powering usb dongle 4G, i always get msg: ... reboot is needed, in the next boot, if the dongle remains on and powered by external hub, then i get the system running and the connection running.
I notice that this kind of message happens in raspbian also when the wifi dongle is plugged, i need help thanks.

This is what i get from dmesg after succesfull boot:
$this->bbcode_second_pass_code('', '
[ 41.473707] usb 1-1.3.4.4: USB disconnect, device number 10
[ 42.097990] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 42.121036] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 42.965187] usb 1-1.3.4.4: new high-speed USB device number 11 using dwc_otg
[ 43.121975] usb 1-1.3.4.4: New USB device found, idVendor=1bbb, idProduct=0195
[ 43.127512] usb 1-1.3.4.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 43.132925] usb 1-1.3.4.4: Product: Mobilebroadband
[ 43.138389] usb 1-1.3.4.4: Manufacturer: Alcatel
[ 43.143659] usb 1-1.3.4.4: SerialNumber: 1234567890ABCDE
[ 43.173695] usb-storage 1-1.3.4.4:1.2: USB Mass Storage device detected
[ 43.179334] scsi host1: usb-storage 1-1.3.4.4:1.2
[ 43.210201] usbcore: registered new interface driver cdc_ether
[ 43.246884] rndis_host 1-1.3.4.4:1.0 usb0: register 'rndis_host' at usb-3f980000.usb-1.3.4.4, RNDIS device, 6e:ea:19:d9:f7:df
[ 43.252789] usbcore: registered new interface driver rndis_host
[ 43.300014] IPv6: ADDRCONF(NETDEV_UP): usb0: link is not ready
[ 44.237431] scsi 1:0:0:0: Direct-Access TIM Chiavetta 4G 2.31 PQ: 0 ANSI: 2
[ 44.247450] sd 1:0:0:0: [sdb] Attached SCSI removable disk
')