PogoPlug v4 (mobile) not boot when USB plugged

[saukerl]

Hi,

I have a Pogoplug Mobile with USB powered Hub with USB stick and USB HDD.

I installed the archlinuxarm following the instructions: http://archlinuxarm.org/platforms/armv5 ... g-series-4 on the USB stick. After that I rebooted and pogoplug is running ok.

After that I installed the samba service following the instructions described:
http://blog.qnology.com/2013/03/tutoria ... linux.html
The samba service, I had linked /media/usb/ on second HDD.

Since then, when I reboot the pogoplug with both disks ( USB stick and USB HDD) the pogoplug stucks on green blingking light.
But if I reboot with only USB stick the pogoplug boots correctly. And when the green light is not blingking I can plug the USB HDD and samba is running correctly.

What could be wrong ?? What can I do to reboot with both USB memory correctly ??

[spooky2012]

Hi saukerl,

Please take a look at this article:

http://mhassan.me/2012/06/27/booting-po ... -usb-disk/

[grayman4hire]

Another option would be to install ALARM on your USB hard drive and skip using the USB flash drive. Just setup your hd with two partitions - a small one of 4GB and the rest for data/samba.