Pogoplug E02 Boot Issue At XCE: led

[bluzfanmr1]

I had successfully been running ARM but was going back to stock on the E02. Watching the serial connection, it's stopping at the following line every time so can anyone provide some guidance as I've looked high and low and can't find anyone else with this problem in the past? I greatly appreciate it.

$this->bbcode_second_pass_code('', 'Starting hbplug: Success
starting pid 341, tty '': '/bin/sh'
-sh-3.2# [ 14.130000] XCE: BLPARAMS: reading 2048 bytes @ a0000
[ 14.140000] XCE: BLPARAMS: reading 2048 bytes @ a0800
[ 14.140000] XCE: BLPARAMS: reading 2048 bytes @ a1000
[ 14.150000] XCE: BLPARAMS: reading 2048 bytes @ a1800
[ 19.500000] XCE: -- 'led0=1'
')

[bluzfanmr1]

I am able to ssh into the machine if that is relevant.

[bluzfanmr1]

I figured it out. I needed to re-register the Pogoplug for anyone that runs across this in the future.